Bega 7027LED flood light 24 volts under ground 77027 B77027/K3/8 NEW 342414

Bega 7027LED flood light 24 volts under ground 77027 B77027/K3/8 NEW 342414. Fast shipping. Notice to Installer for 7027LED:1. Fixture is pre-wired with two 10’ lengths of #12 AWG THHN wires and a waterproof cable gland entry into housing. DO NOT DISTURB THE SEAL. 2. This in-ground luminaire must be supplied by a UL Listed Class 2 remote 24V DC power supply. 3. The fixtures are wet location rated, not submersible, they should not be installed in “low” points of concrete or earth installations where they are going to be submerged underwater for an extended period of time. 4. A level surface MUST be provided for proper installation.5. Lamp supplied with luminaire.6. WARNING: LEDs are high quality electrical components. Please avoid touching them directly during installation. NOTE: BEGA Fixtures may be damaged if connected to a conduit system that contains water. Article 300-5G of the National Electric Code requires that “conduits or raceways through which moisture may contact energized live parts shall be sealed or plugged at both ends”. 7027LED installation:1. The luminaire housing must be firmly mounted to a proper foundation. The top edge of the luminaire housing must be flush to the prepared floor. Failure to due so may result in the fixture not sealing properly and void the warranty. 2. Anchor the fixture to a foundation suitable for the intended vehicular or pedestrian loads. NOTE: MAKE SURE TO ALIGN THE FIXTURE HOUSING SO THE TRIM WILL BE ORIENTED AS PER DESIGN SPECS. 3. Connect the fixture to 1/2” plastic or steel conduit. Pull the provided 10’ of wire through the conduit and thread conduit into provided brass adapter. DO NOT DISTURB THE FACTORY SEAL OF THE CONDUIT CONNECTOR. Use a suitable thread sealer on the 1/2” NPS conduit entry.4. Finish the f