C10 Chev Multi Colors Bed Rail Square Bod Short & Long Box 1970-88 Decal Kit X 2

C10 Chevrolet Square Body 1970-88 for Short or Long Box Bed Rail Wood Grain Panel Stickers Assorted Kits X 2 Each strip is 82" long. More than enough for your GM Bed rails WHY NOT MAKE YOUR BED RAILS LOOK NEW AGAIN? PLEASE SPECIFY & MESSAGE US ON WHICH ONE YOU WOULD LIKE UPON ORDERING NO RETURNS, NO REFUNDS on these custom orders Bed Rails Panel Wood Trim Vinyl Inserts Stickers for your existing Bed Rail Classic X 2***Stickers Only, Bed Rails Not Included*** To cover over the existing aluminum Bed Rail wood grain factory stickers or if they are missing, faded or half missing.You will receive a total of 2 individual Stickers that will be 82" long. That is long enough and enough material to cover both Left & Right side Bed rails short box or long box.Professionally made with high quality 3M Adhesive VinylAll vinyl decals are printed with UV solvent based inks on commercial printers,individually hand-made and designedPressure activated adhesive, laminated with UV resistant PVC for extra durability & protection Easy to remove with no residue left behind, waterproof. UV & Scratch resistant Dimensions listed are rounded to the nearest inch: Bed Rail wood trim ( Qty # 2 - 1" X 82" ) (makes for super easy and great looking installation every time)- Other Sizes Available -(contact us for details) - Satisfaction Guaranteed or Your Money Back -(item must be returned unused and you pay return shipping)- Made, Sold & Shipped by Sticka Steve's - Application Instructions1. When you receive your order, your decal will consist of two layers. The bottom layer is the backing paper, and the top layer is the actual vinyl decal.2. Clean the surface and make sure there is no dust or grease before application.3. Peel of the decal from the backing paper.4. Position and stick the application film on the target surface. Rub the surface of application film with a finger, credit card or dried towel to make sure there's no air bubble caught inside the vinyl decal.5. Peel off the application film slowly and carefully at a very low angle. Make sure the vinyl decal stick on the surface. If there is any difficulties removing the application film, please leave the film on the surface longer.