PICKIT3 Programmer + PIC ICD2 PICKit 2 PICKIT 3 Programming Adapter Universal PICKIT3 Programmer Description:USB (Full speed 12 Mbits/s interface to host PC)Real-time executionMPLAB IDE compatible (free copy included)Built-in over-voltage/short circuit monitorFirmware upgradeable from PC/web downloadTotally enclosedSupports low voltage to 2.0 volts (2.0v to 6.0v range)Diagnostic LEDs (power, busy, error)Read/write program and data memory of microcontrollerErase of program memory space with verificationFreeze-peripherals at breakpointProgram up to 512K byte flash with the Programmer-to-GoThe MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer\'s PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). Universal Programmer Seat Description:Instructions for use:Installing the microcontroller, 28-pin, 40-pin microcontroller left aligned 28/40P (A) This flag line short-circuit cap on the A position.The 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B position.The ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming the programming operation. (Note: a separate program of the seat can not be programmed the chip is programmed functions) The seat supports the following programming microcontroller: PIC16/18XX 40PIN Series devices (except 16F59)PIC16/18XX 28PIN Series devices (except 16F57)PIC16/18XX 18PIN Series devicesThe PIC 8PIN/14PIN/20PIN family of devices (except 10FXX) Package Included:1 X PICKIT2 Simulator1 X USB cable1 X 6pin cable1 x Universal Programmer Seat