$1,350.00
On Hold
250 Series Softail Frame - Custom Chopper / Motorcycle Frames
5 available
Details
Shipping: US-Mainland: free (more destinations)
Sales Tax: check
Condition: Brand new
*The store has not been updated recently. You may want to contact the merchant to confirm the availability of the product.
Frame is shipped raw - painted for picture only.
Dimensions:
Rake of 38 degrees.
80 Degree stretch downtube.
23-1/2" Length single downtube.
26" backbone.
Material:
1020 DOM steel tubing.
Downtube is 1-3/4" O.D. with .219" wall thickness.
Cradle tubes are is 1-3/8" O.D. with .125" wall thickness.
Backbone & seat post are 1-1/2" O.D. with .219" wall thickness.
Special features:
TIG Welded.
Accepts 11" fender.
Accepts Softail® style oil tank.
Accepts 250 rear tire with full width 1.5" belt.
Integral 5th bolt mounting within reinforced offset trans plate.
Included additionally:
Radius style fender struts for 11" fender (not shown).
Heavy duty swing arm, with 1" axle (not shown).
Front oil tank mount, polished stainless steel splash guard
with mounting hardware.
Rear frame pivot tube and hardware including pivot bearings & spacers.
NOTE 1: Requires a 1-1/4" engine-to-inner primary spacer.
NOTE 2: Gas tank mounts, coil mounts & regulator mounts
must be determined by builder.
NOTE 3: Backbone is measured from back of neck to front
of seat plate gusset. Downtube is measured from
bottom of neck to top of cradle tube joint.
***Motorcycles modified with some aftermarket parts, accessories and performance engine parts may be restricted from use on public roads and/or limited to closed courses. Please see U.S. EPA and your respective state regulations. We advise having all parts installed by a qualified motorcycle mechanic for safety and proper installation.***
Dimensions:
Rake of 38 degrees.
80 Degree stretch downtube.
23-1/2" Length single downtube.
26" backbone.
Material:
1020 DOM steel tubing.
Downtube is 1-3/4" O.D. with .219" wall thickness.
Cradle tubes are is 1-3/8" O.D. with .125" wall thickness.
Backbone & seat post are 1-1/2" O.D. with .219" wall thickness.
Special features:
TIG Welded.
Accepts 11" fender.
Accepts Softail® style oil tank.
Accepts 250 rear tire with full width 1.5" belt.
Integral 5th bolt mounting within reinforced offset trans plate.
Included additionally:
Radius style fender struts for 11" fender (not shown).
Heavy duty swing arm, with 1" axle (not shown).
Front oil tank mount, polished stainless steel splash guard
with mounting hardware.
Rear frame pivot tube and hardware including pivot bearings & spacers.
NOTE 1: Requires a 1-1/4" engine-to-inner primary spacer.
NOTE 2: Gas tank mounts, coil mounts & regulator mounts
must be determined by builder.
NOTE 3: Backbone is measured from back of neck to front
of seat plate gusset. Downtube is measured from
bottom of neck to top of cradle tube joint.
***Motorcycles modified with some aftermarket parts, accessories and performance engine parts may be restricted from use on public roads and/or limited to closed courses. Please see U.S. EPA and your respective state regulations. We advise having all parts installed by a qualified motorcycle mechanic for safety and proper installation.***
