is a medium viscosity cutting fluid for most applications. It is designed to keep the cutting tool and material cool, increase tool life and increase output. It performs well for diamond grinding of glass and ceramics, and machining and drilling of most metals. Free rinsing with water clean-up. Syringe dispenser with tips allow for precise application. Features : Keeps tool cool. Extends tool life - save your expensive drill bits and diamond grinding burrs Increases cutting throughput dramatically. Medium Viscosity stays in place, avoids runs and drips. Higher viscosity performs better than automotive coolant or liquid cutting fluids. Dispenser allows for precise application.10cc syringe contains 8ccs of gel- enough for dozens of cuts! Includes 3 dispensing reusable tips. Free rinsing, water clean up. Works for cutting, drilling, or grinding most non-porous materials. Performance Study: Grinding of glass. A 1/8" diamond coated grinding burr was used to cut a slot in a glass vase with a Dremel Rotary Tool. A few drops of were applied to the surface of the material and the tip of the cutting tool. The material was cut for a total of 4 minutes stopping to apply a few more drops at one minute intervals. 4 Minutes of cutting WITHOUT Total cut length was less than 1/2" The diamond bit was extremely hot, too hot to touch. The glass surface was hot. The grinding bit was toast!4 Minutes of cutting WITH Total cut length was about 1-3/4" The diamond bit was near room temperature The glass was near room temperature. The grinding bit was ready to keep going! A few warnings and cautions: We can not offer advice on a specific application. For use by experienced craters and machinists. User assumes all risk for application.Any warranties are limited to replacement or refund of product.Always wear safety glasses when working with cutting or grinding tools!NOTE: This item only ships within the US!