Tyan Titan Turbo AT2 Motherboard
with Intel Pentium 75Mhz processor and 32 Mb of Ram installed.
Intel 430TX chipset with support for CPU speeds up to 233 MHz.
The Titan Turbo AT2 will support the CyrixM1/6x86 CPU's, AMD K6, & Intel multimedia Pentium with MMX processor, both the P55C and P54CTB Overdrive versions.
The Titan Turbo AT2 is an integrated system board which achieves a high reliability with numerous features:
on-board dual channel PCI PIO, DMA IDE and
UltraDMA/33, on-board floppy controller, on-board high speed I/O, and on-board 512k burst SRAM.
Flexibility and expandibility have been designed into the Titan Turbo AT2. With I/O and drive controller support built on-board, the five PCI and four ISA (One ISA and one PCI as a shared slot) slots are free for numerous add-on expansion cards.
Specifications
Processor Support-
Pentium/Pentium MMX/AMD K6
Supports 75 - 233 MHz
Cyrix/SGS/IBM 6x86 P120+, P150+, P166+
M2/K6 233 MHz Support built-in
ZIF Socket 7/ Wide Voltage Range
Chipset
- Intel 430TX PCIset
System Memory-
8-256MB; six 72-pin SIMM Sockets
Two 168-pin DIMM Sockets
Fast Page Mode or EDO DRAM Support
EDO DIMM and SDRAM Support
Cache Memory - On-board 512K Burst Cache
Expansion Slots-
Five 32-bit PCI Bus Mastering Slots
Four 16-bit ISA Slots
One Shared PCI/ISA Slot - 8 usable
Disk Drive & System I/O-
On-board PCI Bus Mastering IDE
Two PCI Bus-Master enhanced IDE Ports
4 HDD + EIDE CD-ROM Support (4 IDE Devices Total); Ultra DMA/33 Support
Bus-Mastering DMA Modes 1 & 2
PIO Modes 3 & 4; On-board I/O with IR
Two Floppy Drives
Two serial ports (16550 UART's)
One ECP/EPP parallel port
One IR (InfraRed) I/O interface port
Two USB rev 1.2 port support
BIOS-
Award standard, AMI BIOS Available
Green PC Compatible
Microsoft Plug and Play Ready; DMI
Form Factor
Intel Baby AT (11" x 8.8") Reduced Form Factor
Manual and information included on CD Rom
NO back panel I/O Plate is included.
This board was refurbished and is in perfect running order.
You Must be aware that this board cannot support
modern EIDE drives, and cannot recognize some
Fujitsu models of hard drives. We suggest using
a controller card or SCSI card for recognizing larger
hard drives.
This board is for replacing a failed/failing system
board that is already in place.
It is fully tested and is known to work perfectly.
We tested it with 8Gb hard drives, including the
fujitsu hard drive that is supposed to be hard for
it to recognize.
Priority Insured FAST shipping, with tracking.
PAYMENT NOTE:
Credit cards are accepted.
The shipping address must
match the billing address of
the credit card.
Please Inquire if this is your
preferred payment method. ... [full description] |
