Viton-GF rubber seals, Viton-B tubing, plus critical small hardware and a few special tools.
Pick Bag: 1 plastic o-ring pick, 1 piece brass shim stock 0.002”x3”x0.25”, and this piece of paper
Bag A: 6 Viton-GF o-rings for Air Cut Valve’s plastic nose
Bag B: 12 Viton-GF o-rings for Air Cut Valve’s brass tube
Bag C: 6 Viton-GF o-rings, 6 springs and 6 washers for Pilot Screw
Bag D: 6 Viton-GF o-rings for Drain Screw
Bag E: 8 Viton-GF o-rings for Fuel Rail
Bag F: 8 Viton-GF o-rings for Air Rail
Bag G: Carb Link Bar Parts: 2 Delrin spring washers, 2 wide stainless washers, 2 black Delrin washers, 2 white Teflon washers, 2 tiny stainless washers, 3 cotter pins (one is a spare)
Bag I: 6 Viton-GF o-rings for CV Sliders (also called Jet Needle o-rings)
Bag J: 6 Viton-B tubes (from Air Cut Valve nipple to Carb nipple)
Bag K: 6 Yellow plastic plugs to keep debris out of the intake ports of the heads while you work
Bag L2: 8 long acetal hollow dowels, 4 short dowels, 5mm pin punch and a piece of 12 AWG copper wire. Instructions included.
Bag M: Carb Pry Tool with 3 brass shims (and instructions)
Bag P: Six Viton-GF gaskets for the air horn (velocity stack)
Bag R: Six Viton-GF plugs for the Air Cut Valve
Bag S: Several fittings to let you test your air cut valves and other devices using your MityVac.
Pictures are available at www.valkparts.com
Instructions are downloadable there.