KT HyperX 8GB DDR3 1866MHz CL9
2x4GB KHX1866C9D3K2/8GX

Kingston 8GB 1866MHz DDR3 Non-ECC CL9 DIMM (Kit of 2)
KHX1866C9D3K2/8G

Overview:
Kingston's KHX1866C9D3K2/8G is a kit of two 512M x 64-bit (4GB) DDR3-1866 CL9 SDRAM (Synchronous DRAM), 2Rx8 memory modules, based on sixteen 256M x 8-bit FBGA components per module. Total kit capcity is 8GB.
Each module pair has been tested to run at DDR3-1866 at a low latency timing of 9-11-9-27 at 1.65V.
The SPDs are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9.
Each 240-pin DIMM uses gold contact fingers.

Features:
JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ: 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB: Height 1.180” (30.00mm), double sided component

Specifications:
Standard 512M X 64 Non-ECC 1866MHz 240-pin Unbuffered DIMM (DDR3, 1.65V, CL9, FBGA, Gold)
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Power (Operating) 1.410 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C

ALL PRICES INCLUDE GST,VAT,TAX

ME8GDDR3-KX1866

AUST GST $ 11.90
UK VAT £ 7.50
US TAX $ 12.05