$9.99
Add to Cart
1ft Decorative Privacy Window windows Film Treatments #023
Width: about 2.95 FT (35 INCHES) (90CM)
Length:1ft
if you buy more than one foot, it will come in one continuous piece
* Great for windows, shower door, entry doors, glass cabinet panels, etc. If you want privacy or decorating, this window film is the solution for you!
how to use?
Step 1: Measure the size of the window glass. Make sure the film to be cut is 1 square cm bigger than the glass itself;
Step 2: Spray the window glass with soap water or detergent water(make sure the water is well-shaked until it has bubbles in it),
Step 3 : Peel the backing from one corner of the film, exposing about 2” of the film in the corner. Position the film in the appropriate corner of the window and align it correctly. Slowly peel away the backing from the film, pressing the film to the glass as you go
Step 4: Adjust the film until it's perfectly centered on the glass or when the glass is 100% covered by the film, then use a bank card to squeeze the bublles out of the film from the top to the bottom;
Step 5: If there are a few water bubbles left under of the film, use a sharp knife or a needle to make a tiny hole at the places where the bubbles are, then use the bank card to squeeze the bubbles out;
Step 6: Use a piece of rag or paper towel to dry the edges of the film, then use the bank card to press them until they are flat and smooth after cutting off the extra margins of the film.
Length:1ft
if you buy more than one foot, it will come in one continuous piece
* Great for windows, shower door, entry doors, glass cabinet panels, etc. If you want privacy or decorating, this window film is the solution for you!
how to use?
Step 1: Measure the size of the window glass. Make sure the film to be cut is 1 square cm bigger than the glass itself;
Step 2: Spray the window glass with soap water or detergent water(make sure the water is well-shaked until it has bubbles in it),
Step 3 : Peel the backing from one corner of the film, exposing about 2” of the film in the corner. Position the film in the appropriate corner of the window and align it correctly. Slowly peel away the backing from the film, pressing the film to the glass as you go
Step 4: Adjust the film until it's perfectly centered on the glass or when the glass is 100% covered by the film, then use a bank card to squeeze the bublles out of the film from the top to the bottom;
Step 5: If there are a few water bubbles left under of the film, use a sharp knife or a needle to make a tiny hole at the places where the bubbles are, then use the bank card to squeeze the bubbles out;
Step 6: Use a piece of rag or paper towel to dry the edges of the film, then use the bank card to press them until they are flat and smooth after cutting off the extra margins of the film.












